Laser Stays On When System Shuts Off
Possible Cause#1
Loose wiring
Solution Set#1
Check all wiring from compressor relay to launcher harness
Faulty crimp
Solution Set#2
Remove crimps from compressor pull down
Possible Cause#3
Bad computer box
Solution Set#3
- Replace computer box
Bad launcher
Solution Set#4
- Replace launcher
Related Articles
Laser Aim Off
Possible Cause#1 Lost memory in stepper Solution Set#1 Put system in training mode and hard park it See StarChase V3.0 Launcher Park Reset Instructions Possible Cause#2 Laser needs re-aimed Solution Set#2 Follow laser aiming instructions See ...
Launcher Fails To Arm; No Laser With System On
Possible Cause#1 Control Panel Connections Solution Set#1 Verify Ignition power Verify 12V and ground connections Ensure Can-Bus Harness is connected ...
Systems Shuts Down When Armed
Possible Cause#1 System timed out Solution set#1 System will time out after 3 minutes of system on Fire system prior to 3 minute time out Turn on system and repeat arming cycle Possible Cause#2 System not getting enough power to operate Solution ...
System Locked-No Elevation, No Laser
Possible Cause#1 No power to Computer Box Solution Set#1 Check fuse for PCM/PCR, replace if bad Check for movement of the launcher and/or compressor operation Check all connections and wiring Check power from PCM/PCR-including disconnecting grey ...
Laser Constantly ON
Possible Cause#1 Water logged computer box Solution Set#1 Replace computer box Possible Cause#2 Short in laser housing Solution Set#2 Replace launcher