Launcher Fails To Arm; No Laser With System On

Launcher Fails To Arm; No Laser With System On

Possible Cause#1
Control Panel Connections

Solution Set#1
  1. Verify Ignition power
  2. Verify 12V and ground connections
  3. Ensure Can-Bus Harness is connected

________________________________________________________________________________________________________________________________________________________

Possible Cause#2
No power from PCM/PCR

Solution Set#2

  1. Check all power fuses

  2. Power up system put in training mode

  3. Check for movement of the launcher and/or compressor operation

  4. Check all connections and wiring

  5. Check power from PCR-including disconnecting grey Delphi and checking power at the connector

    1. Orange Wire - 12VDC

    2. Black Wire - Ground

    3. Red Wire - 5VDC

  6. Replace PCM/PCR

______________________________________________________________________________________________________________________________________________________________


Possible Cause#3
Defective Computer Box

Solution Set#3

  1. "Plug in" new Computer Box to test