Launcher Is Cycling Elevation Constantly
Possible Cause#1
Possible bad PCM/PCR
Solution Set#1
- Check all power fuses
Power up system put in training mode
Check for movement of the launcher and/or compressor operation
Check all connections and wiring
Check power from PCR-including disconnecting grey Delphi and checking power at the connector
Orange Wire - 12VDC
Black Wire - Ground
Red Wire - 5VDC
Replace PCM/PCR
Possible Cause#2
Laser shorted
Solution Set#2
Check resistance between pins 9 and 10. If resistance is 1ohm replace launcher (proper resistance is 8.92kohm)
Related Articles
No Fire In Training Mode, No Launcher Elevation, CP and Laser On, Pressure Good
Possible Cause#1 Bad CB, PCM/PCR, or 12V connection to PCM/PCR Solution Set#1 Check for 12V going into PCM/PCR. If no 12V check fuse for PCM/PCR. If 12V present proceed to next step Check for 12V at orange wire on 4 Pin connector. If no 12V replace ...
Intermittent Elevation
Possible Cause#1 Console was wired backwards/incorrectly Solution Set#1 Failed to hard park when in training mode (all connections flowed with the movement of the Launcher so nothing was preventing it from moving) System blew the 20 amp fuse to the ...
Launcher Air Leak
Possible Cause#1 Faulty Pressure Switch Solution Set#1 Replace pressure switch/valve assembly Possible Cause#2 Hose malfunction Solution Set#2 Fitting at the launcher not seated correctly
Rounds Not Reporting In Launcher
Possible Cause#1 Not properly seated Solution Set#1 Confirm that rounds are seated properly Arm system and check to see if rounds come up on mapping Replace rounds Possible Cause#2 Battery dead Solution Set#2 Replace round Possible Cause#3 No ...
Launcher No Elevation
Possible Cause#1 Broken stepper Solution Set#1 Replace launcher