No Laser "ON" On Launcher
Possible Cause#1
No power to PCM/PCR
Solution Set#1
Check 12V power to PCM/PCR
Check ground to PCM/PCR
Check 5VDC to PCM/PCR
Replace 15A fuse for PCM/PCR
No power to control panel
Solution Set#2
Check 12VDC power to control panel
Check "IGNITION" to control panel
Check ground for control panel
Replace control panel
Possible Cause#3
No power to laser
Solution Set#3
- Replace computer box
Bad laser
Solution Set#4
- Replace launcher
Related Articles
Laser Constantly ON
Possible Cause#1 Water logged computer box Solution Set#1 Replace computer box Possible Cause#2 Short in laser housing Solution Set#2 Replace launcher
Laser Aim Off
Possible Cause#1 Lost memory in stepper Solution Set#1 Put system in training mode and hard park it See StarChase V3.0 Launcher Park Reset Instructions Possible Cause#2 Laser needs re-aimed Solution Set#2 Follow laser aiming instructions See ...
No Compressor Or Launcher Control, Laser works
Possible Cause#1 Defective PCM/PCR, fuse, wiring Solution Set#1 Check all power fuses Power up system put in training mode Check for movement of the launcher and/or compressor operation Check all connections and wiring Check power from ...
Launcher Fails To Arm; No Laser With System On
Possible Cause#1 Control Panel Connections Solution Set#1 Verify Ignition power Verify 12V and ground connections Ensure Can-Bus Harness is connected ...
Launcher Is Cycling Elevation Constantly
Possible Cause#1 Possible bad PCM/PCR Solution Set#1 Check all power fuses Power up system put in training mode Check for movement of the launcher and/or compressor operation Check all connections and wiring Check power from PCR-including ...