Rounds Not Reporting In Launcher
Possible Cause#1
Not properly seated
Solution Set#1
Confirm that rounds are seated properly
Arm system and check to see if rounds come up on mapping
Replace rounds
Battery dead
Solution Set#2
Replace round
Possible Cause#3
No satellite lock
Solution Set#3
- Confirm vehicle is parked in clear view to ensure unobstructed view to satellite
- Drive vehicle to see if satellite will lock in (may take up to an hour if initial satellite connection was missed)
Issue with launcher
Solution Set#4
- Confirm launcher barrel is clean, no glue or debris is in the barrel
- Check detents of launcher barrel
- Confirm PST lights on control panel are lit
- Test barrel with round that is currently updating
- Run vehicle for at least 30 minutes and arm system
- Remove and reinstall fuses (this will cause a hard reboot)
- Replace launcher
Related Articles
Rounds Not Reporting In Mapping Website
Possible Cause#1 GPS rounds faulty Solution Set#1 Confirm PST lights on Control Panel are lit Confirm vehicle is parked in clear view to ensure unobstructed view to satellite Drive vehicle to see if satellite will lock in (may take up to an hour if ...
Rounds Not Deploying Properly
Possible Cause#1 Screws loose on Door Cover Solution Set#1 Check and tighten screws on Door Possible Cause#2 Round flips after being deployed Solution Set#2 Round hit door during deployment Officer did "hard braking" during deployment ...
Launcher Air Leak
Possible Cause#1 Faulty Pressure Switch Solution Set#1 Replace pressure switch/valve assembly Possible Cause#2 Hose malfunction Solution Set#2 Fitting at the launcher not seated correctly
Launcher Is Cycling Elevation Constantly
Possible Cause#1 Possible bad PCM/PCR Solution Set#1 Check all power fuses Power up system put in training mode Check for movement of the launcher and/or compressor operation Check all connections and wiring Check power from PCR-including ...
No Compressor Or Launcher Control, Laser works
Possible Cause#1 Defective PCM/PCR, fuse, wiring Solution Set#1 Check all power fuses Power up system put in training mode Check for movement of the launcher and/or compressor operation Check all connections and wiring Check power from ...