Related Articles
When System is armed, the arm button will blink for approx. 10 seconds, the ON and OFF button will turn off then on again, and the arming cycle resets
Possible Cause#1 Wires for the pressure switch shorting out the system and causing malfunction. Repair the wires Solution Set#1 Test the Compressor Check power fuses (25Amp) at battery. Ground single pin to compressor relay to ground to test ...
No Power To Control Panel
Possible Cause#1 Main power fuse for control panel is blown Solution Set#1 Replace fuse for main power Possible Cause#2 Ignition fuse is blown Solution Set#2 Replace fuse for ignition Possible Cause#3 Vehicle battery is below 10.5VDC Solution Set#3 ...
Launcher Elevated Up, Door Won't Unlatch
Possible Cause#1 Loose wiring Solution Set#1 Check orange wire that runs from control panel to computer box Complete tug test to ensure wire is secure Replace wire by pulling the metal retaining tang upward and push the wire back into the connector ...
Systems Shuts Down When Armed
Possible Cause#1 System timed out Solution set#1 System will time out after 3 minutes of system on Fire system prior to 3 minute time out Turn on system and repeat arming cycle Possible Cause#2 System not getting enough power to operate Solution ...
Launcher Fails To Arm; No Laser With System On
Possible Cause#1 Control Panel Connections Solution Set#1 Verify Ignition power Verify 12V and ground connections Ensure Can-Bus Harness is connected ...