When Pressing "ON" System Starts Powering Up Sequence But Cycle Stops Abruptly

When Pressing "ON" System Starts Powering Up Sequence But Cycle Stops Abruptly

Possible Cause#1
  1. Bad car battery leading to a low voltage results in failure to power StarChase system
  2. Car alternator needs work/replaced
Solution Set#1

  1. Check to see if "ON" and "Down Arrow" buttons are illuminated



    • Related Articles

    • System Shutting Off Randomly After Armed To Fire

      Possible Cause#1 Bad car battery leading to a low voltage results in failure to power StarChase system Solution Set#1 Verify connections Check Fuse Holders Ensure vehicle had enough time to charge battery post installation

    • Launcher Fails To Arm; No Laser With System On

      Possible Cause#1 Control Panel Connections Solution Set#1 Verify Ignition power Verify 12V and ground connections Ensure Can-Bus Harness is connected ...

    • System Does Not Finish Power Up Sequence

      Possible Cause#1 Bad car battery leading to a low voltage reading in system checks and failure to power StarChase system Solution Set#1 Car battery needs replaced

    • DS Valve Not Firing

      Possible Cause#1 DS will not fire Solution Set#1 In training mode PS will always fire first Fired PS in training mode then system timed out Ensure system is fired for both barrels before system times out Solution Set#2 In Normal mode system will fire ...

    • Laser Aim Off

      Possible Cause#1 Lost memory in stepper  Solution Set#1 Put system in training mode and hard park it See StarChase V3.0 Launcher Park Reset Instructions Possible Cause#2 Laser needs re-aimed Solution Set#2 Follow laser aiming instructions See ...