When System is armed, the arm button will blink for approx. 10 seconds, the ON and OFF button will turn off then on again, and the arming cycle resets
Possible Cause#1
Wires for the pressure switch shorting out the system and causing malfunction. Repair the wires
Solution Set#1
Test the Compressor
Check power fuses (25Amp) at battery.
Ground single pin to compressor relay to ground to test compressor.
If compressor does not turn on, replace compressor relay.
Check wires from the Launcher to Pressure Switch Manifold
Related Articles
Systems Shuts Down When Armed
Possible Cause#1 System timed out Solution set#1 System will time out after 3 minutes of system on Fire system prior to 3 minute time out Turn on system and repeat arming cycle Possible Cause#2 System not getting enough power to operate Solution ...
System Shutting Off Randomly After Armed To Fire
Possible Cause#1 Bad car battery leading to a low voltage results in failure to power StarChase system Solution Set#1 Verify connections Check Fuse Holders Ensure vehicle had enough time to charge battery post installation
Launcher Fails To Arm; No Laser With System On
Possible Cause#1 Control Panel Connections Solution Set#1 Verify Ignition power Verify 12V and ground connections Ensure Can-Bus Harness is connected ...
When Pressing "ON" System Starts Powering Up Sequence But Cycle Stops Abruptly
Possible Cause#1 Bad car battery leading to a low voltage results in failure to power StarChase system Car alternator needs work/replaced Solution Set#1 Check to see if "ON" and "Down Arrow" buttons are illuminated
System Fails To Cycle To Fire
Possible Cause#1 Loose ignition wire Solution Set#1 Check ignition wiring Tighten or replace any loose or frayed wiring Possible Cause#2 Faulty Manifold Solution Set#2 Replace Pressure Manifold