System Does Not Finish Power Up Sequence

• Related Articles

• When Pressing "ON" System Starts Powering Up Sequence But Cycle Stops Abruptly

  Possible Cause#1 Bad car battery leading to a low voltage results in failure to power StarChase system Car alternator needs work/replaced Solution Set#1 Check to see if "ON" and "Down Arrow" buttons are illuminated

• No Power To Launcher

  Possible Cause#1 No 12V power Solution Set#1 Check 12VDC Power to PCM/PCR Check ground to PCM/PCR Check 5VDC to PCM/PCR Replace 15A fuse for PCM/PCR Possible Cause#2 Bad PCM/PCR Solution Set#2 Replace PCM/PCR Possible Cause#3 Bad computer box ...

• System Shutting Off Randomly After Armed To Fire

  Possible Cause#1 Bad car battery leading to a low voltage results in failure to power StarChase system Solution Set#1 Verify connections Check Fuse Holders Ensure vehicle had enough time to charge battery post installation

• No Power To Control Panel

  Possible Cause#1 Main power fuse for control panel is blown Solution Set#1 Replace fuse for main power Possible Cause#2 Ignition fuse is blown Solution Set#2 Replace fuse for ignition Possible Cause#3 Vehicle battery is below 10.5VDC Solution Set#3 ...

• Launcher Fails To Arm; No Laser With System On

  Possible Cause#1 Control Panel Connections Solution Set#1 Verify Ignition power Verify 12V and ground connections Ensure Can-Bus Harness is connected ...