System Fails To Cycle To Fire

• Related Articles

• Launcher Fails To Arm; No Laser With System On

  Possible Cause#1 Control Panel Connections Solution Set#1 Verify Ignition power Verify 12V and ground connections Ensure Can-Bus Harness is connected ...

• System Shutting Off Randomly After Armed To Fire

  Possible Cause#1 Bad car battery leading to a low voltage results in failure to power StarChase system Solution Set#1 Verify connections Check Fuse Holders Ensure vehicle had enough time to charge battery post installation

• When Pressing "ON" System Starts Powering Up Sequence But Cycle Stops Abruptly

  Possible Cause#1 Bad car battery leading to a low voltage results in failure to power StarChase system Car alternator needs work/replaced Solution Set#1 Check to see if "ON" and "Down Arrow" buttons are illuminated

• When System is armed, the arm button will blink for approx. 10 seconds, the ON and OFF button will turn off then on again, and the arming cycle resets

  Possible Cause#1 Wires for the pressure switch shorting out the system and causing malfunction. Repair the wires Solution Set#1 Test the Compressor Check power fuses (25Amp) at battery. Ground single pin to compressor relay to ground to test ...

• System Does Not Finish Power Up Sequence

  Possible Cause#1 Bad car battery leading to a low voltage reading in system checks and failure to power StarChase system Solution Set#1 Car battery needs replaced