No Compressor Or Launcher Control, Laser works
Possible Cause#1
Defective PCM/PCR, fuse, wiring
Solution Set#1
Check all power fuses
Power up system put in training mode
Check for movement of the launcher and/or compressor operation
Check all connections and wiring
Check power from PCM/PCR-including disconnecting grey Delphi and checking power at the connector
Orange Wire - 12VDC
Black Wire - Ground
Red Wire - 5VDC
Replace PCM/PCR
Related Articles
Launcher Fails To Arm; No Laser With System On
Possible Cause#1 Control Panel Connections Solution Set#1 Verify Ignition power Verify 12V and ground connections Ensure Can-Bus Harness is connected ...
Launcher Is Cycling Elevation Constantly
Possible Cause#1 Possible bad PCM/PCR Solution Set#1 Check all power fuses Power up system put in training mode Check for movement of the launcher and/or compressor operation Check all connections and wiring Check power from PCR-including ...
Laser Aim Off
Possible Cause#1 Lost memory in stepper Solution Set#1 Put system in training mode and hard park it See StarChase V3.0 Launcher Park Reset Instructions Possible Cause#2 Laser needs re-aimed Solution Set#2 Follow laser aiming instructions See ...
Control Panel Will Not Operate Launcher
Possible Cause#1 Damage to control panel and components Solution Set#1 Replace the control panel
No Laser "ON" On Launcher
Possible Cause#1 No power to PCM/PCR Solution Set#1 Check 12V power to PCM/PCR Check ground to PCM/PCR Check 5VDC to PCM/PCR Replace 15A fuse for PCM/PCR Possible Cause#2 No power to control panel Solution Set#2 Check 12VDC power to control panel ...